Определитель повреждения кабеля (TDR) TX Ranger

TXRanger

New product

The TX Ranger is a hand-held Time Domain Reflectometer (cable fault locator) with a first range of 2.5 meters combined with a 1.3 Nano second pulse width gives a blind zone of only 5 cm, it makes this the ideal product for fault location on short cable assemblies and harnesses. Small and intermittent faults can be easily identified by using the selectable gain control allowing trace amplification of up to 7 times and when set to scan lock mode the advanced noise reduction software may be selected allowing the user to select between 8,16 and 32-point trace averaging further enhancing the clarity of the trace by reducing electrical and environmental interference.

  • Short Range Graphical TDR; 
  • Up to 700m; 
  • Deadzone 0.2m; 
  • Selective Gain; 
  • Trace Comparisons; 
  • USB download to PC. 

More details

Bi Communications

 

По заказу

859,00 € Без НДС

0.6 kg

  • USB 2.0 Interface with a Windows compatible software TraceXtra to download/analyse traces
  • Rugged Palm-Top design
  • Weighs less than 350g (12oz)
  • 11 Measurement Ranges up to 6000m(6km)
  • 25, 50, 75 & 100ohm Selectable Cable Impedance
  • Memory capacity upto 50 saved traces
  • Built in Tone Generator for Pair Tracing and Identification
  • Suitable for testing all Communication and Power Cables
  • Environmental Protection IP54
  • CE Approved
  • Soft bag & Test Leads

The TX Ranger is a hand-held Time Domain Reflectometer (cable fault locator) with a first range of 2.5 meters combined with a 1.3 Nano second pulse width gives a blind zone of only 5 cm, it makes this the ideal product for fault location on short cable assemblies and harnesses. Small and intermittent faults can be easily identified by using the selectable gain control allowing trace amplification of up to 7 times and when set to scan lock mode the advanced noise reduction software may be selected allowing the user to select between 8,16 and 32-point trace averaging further enhancing the clarity of the trace by reducing electrical and environmental interference.

With an onboard storage capacity of up to 50 traces including time/date, impedance, Velocity of Propagation, cursor position, range and gain value. These may be recalled and used for comparison with current cables under test or downloaded to the PC via the USB link and TRACEXTRA PC software provided. Historical data stored on the PC may also be uploaded to the Ranger for comparison with current measurements.

Дисплей 128 x 64 pixel (back lit)
Элементы питания 6 volts 4 x 1.5 AA Alkaline cells
Время работы 20 hours continuous scanning (subject to use of backlight)
Размеры 165 x 90 x 37 (6.5 x 3.5 x 1.5 ins)
Вес 350 gms (12oz)
Класс защиты Water/Dust Proof IP54
Условия эксплуатации -10º / 50ºC
Условия хранения -20º / 70ºC
Разршение Approx 1% of range
Точность 1% of selected range*
Коэффициент скорости Adjustable from 1% to 99% or Feet Meters / Micro Second
Память 50 Traces
Диапазон Meters: 2.5, 5, 10, 20, 40, 80, 160, 320, 640; Feet: 7, 15, 30, 60, 120, 240, 500, 1000, 2000. Manual range control
Чувствительность Min 10 pixel return at 640m on 0.6mm Ø, PE, TP
Gain Preset for Range Scale selected, but with adjustable settings to 7x magnification.
Выходной импульс 5 volts peak to peak. Into open circuit
Выходное сопротивление Selectable 25, 50, 75 & 100 ohms
Ширина выходного импульса 1.3ns, Automatic with range
Скорость сканирования 2 scans / second or scan held
Усреднение трассировки User selectable, Disabled, 8, 16 or 32 point trace
Защита по напряжению 250 volts AC
Тон генератор 810 – 1100Hz
Выключение Selectable 1, 2, 3 minutes or disabled
Безопасность IEC 61010-1
Burst EN 60950
EMC BS/EN 61326-1

Еще нет отзывов.

Написать отзыв

Определитель повреждения кабеля (TDR) TX Ranger

Определитель повреждения кабеля (TDR) TX Ranger

The TX Ranger is a hand-held Time Domain Reflectometer (cable fault locator) with a first range of 2.5 meters combined with a 1.3 Nano second pulse width gives a blind zone of only 5 cm, it makes this the ideal product for fault location on short cable assemblies and harnesses. Small and intermittent faults can be easily identified by using the selectable gain control allowing trace amplification of up to 7 times and when set to scan lock mode the advanced noise reduction software may be selected allowing the user to select between 8,16 and 32-point trace averaging further enhancing the clarity of the trace by reducing electrical and environmental interference.

  • Short Range Graphical TDR; 
  • Up to 700m; 
  • Deadzone 0.2m; 
  • Selective Gain; 
  • Trace Comparisons; 
  • USB download to PC. 
Description Language Ver. Link
TXRanger SW Quick Start Guide English TXRanger QSG, EN
TXRanger Users manual English TXRanger Manual, EN

В этой категории 10 товаров: