Передатчик для труб MPL7

Новый товар

MPL7 is flexible and only 7mm diameter transmitter sonde for tracing microduct and other tube blockages. It is very useful when new cables are to be pushed into old ducts, which already have installed cables or other obstacles. MPL7-10 is compatible with Vesala’s 10kHz wire and cable tracers.

Подробнее

 

0.071 kg

Добавить в избранное

MPL7 is flexible and only 7mm diameter transmitter sonde for tracing microduct and other tube blockages. It is very useful when new cables are to be pushed into old ducts, which already have installed cables or other obstacles. MPL7-10 is compatible with Vesala’s 10kHz wire and cable tracers.

The MPL7-10 construction includes the transmitter unit and battery compartment, which are connected together. The semi-rigid construction helps the device pass tube curves, joints and obstacles easily. This way constructor can validate if ducts are usable for new cables or not. MPL7 is intended for ducts having inner diameter of 10mm or more.

Working with MPL7

MPL7 turns on and starts sending tracing signal when a battery is inserted and the battery compartment is turned to the middle part. The sonde is attached to the tip of a push rod (snake) by its M6 female thread, located at the end of the battery compartment. Alternatively the sonde can be taped to the side of the push rod to reduce risk of damage.

After that the sonde is pushed into the duct. If there is a blockage in the duct, its location can be roughly estimated using the length of the rod and cable & duct maps. After that the exact location of MPL7-10 is traced in the area above ground with a cable tracer receiver. Knowing the exact spot of a blockage considerably saves time and reduces unnecessary digging costs.

There is a blinking red light at the tip of the transmitter indicating transmitter operation. The disposable lithium battery unit gives energy for approx. 9 hours total usage.

MPL7 diameter is 7.5mm and length with mounted battery compartment 114mm.

Размеры Length 114 mm
Диаметр 7.5 мм
Частота MPL7-10 (10kHz), MPL7-33 (33kHz)
Класс защиты передатчика IP67 / IK07
Элементы питания передатчика CR535
Время работы передатчика 9 h
Рабочая дальность в открытом воздухе MPL7-10 - 3.3m; MPL7-33 - 5.1m
Рабочая дальность в чугунной трубе 0 m
  • Компактный локатор СL43 это доступный и простой в применении кабелеикатель, сискатель проводов и искатель передатчиков для труб. Вне помещений CL43 может применяться для поиска подземных кабелей на глубине от нескольких метров. Внутри помещений CL43 может применяться для поиска, например, кабелей или проводов внутри стен, поиска кабелей напольного отопления и пр.

  • Battery compartment MPL7-M5 with M5 mounting thread for MPL7 duct sondes

Еще нет отзывов.

Написать отзыв

Передатчик для труб MPL7

Передатчик для труб MPL7

MPL7 is flexible and only 7mm diameter transmitter sonde for tracing microduct and other tube blockages. It is very useful when new cables are to be pushed into old ducts, which already have installed cables or other obstacles. MPL7-10 is compatible with Vesala’s 10kHz wire and cable tracers.

Базовый комплект MPL7

1. Передатчик MPL7-10 или MPL7-33, 1 шт.
2. Отсек для элемента питания с резьбой М6, 1 шт.
3. Пластиковый футляр карманного размера, 1 шт.
4. Руководство по эксплуатации на английском, финском, шведском или русском языке, 1 шт.
5. Элементы питания, 2 шт.

Видео демонстрация


 

Описание Язык Вер. Ссылка
Техническое описание передатчиков для труб Английский 1805 Duct sondes, EN

В этой категории 12 товаров: