Saatja torude jaoks PL18-05

PL18-05

Uus toode

PL18-05 is a low frequency (512Hz) pipe transmitter sonde, which enables tracing of underground cast iron ducts and their blockages. Also stainless steel ducts commonly used in industry can be followed and checked with PL18-05.

Rohkem infot

 

0.2 kg
)

Lisa soovinimekirja

PL18-05 is a low frequency (512Hz) pipe transmitter sonde, which enables tracing of underground cast iron ducts and their blockages. Also stainless steel ducts commonly used in industry can be followed and checked with PL18-05.

PL18-05 powers on when the battery compartment is turned to the transmitter section. Red power-on LED at the tip of the sonde indicates operation. If LED goes off, battery is weak. Sonde is attached to the push rod (snake) with the M12 threaded sleeve or with tape. After that the sonde is pushed into the target duct using the push rod.

All PL18-series sondes can be mounted to a variety of push rods. Standard mounting is for rods with M12 male thread. With the PL18-FM flexible mounting accessory also M6 rods can be used and the PL-MSA accessory enables M5 and M10 rods.

To avoid loosing signal e.g. at corners the sonde is traced with a cable tracer receiver along as it moves ahead. If sonde hits an obstacle or blockage, it’s possible to define the location and depth very accurately, which reduces unnecessary digging.

PL18-05 diameter is 18.2mm and length with stardard battery compartment is 110mm. Transmitted signal is continuous 512Hz.

Mõõdud Length: 98 mm
Läbimõõt 18 mm
Sagedus 512 Hz
Transmitter appliance class IP68 / IK08
Saatja tööaeg 5h
Töökaugus vaba õhus 13m
Töökaugus metalltorus 8.4m
  • LS14250 is a 3.6V Lithium battery suitable for the PL18-05, PL18-10 and PL18-33 duct transmitter sondes. Battery capacity is typically 1200mAh but it may vary depending on the manufacturer. Battery maximum size is approx. 14.6 x 25.2mm. Battery is sold by piece.

  • CL43 Compact Locator is an affordable and easy-to-use wire and cable and duct sonde locator. Outdoors CL43 can be used to trace and pinpoint underground cables from several metres depth. Indoors CL43 can be used to locate for example floor heating cables and wires inside walls.

  • Mounting adapter PL-MSA (for PL18 and M10 & M5 push rods)

  • Mounting adapter PL18-FM, flexible (for PL18 and M12 & M6 push rods)

  • Battery compartment PL18-M10M with M10 male mounting thread for PL18 duct sondes

Hetkel pole ühtegi ülevaadet

Kirjutage oma ülevaade

Saatja torude jaoks PL18-05

Saatja torude jaoks PL18-05

PL18-05 is a low frequency (512Hz) pipe transmitter sonde, which enables tracing of underground cast iron ducts and their blockages. Also stainless steel ducts commonly used in industry can be followed and checked with PL18-05.

PL18 Põhikomplekt

1. Saatja PL18-10, PL18-33 või PL18-05, 1 tk
2. Patareipesa M2 keerega, 1 tk.
3. Hoiukarp, 1 tk.
4. Kasutusjuhend Inglise, Soome, Rootsi või Vene keeles, 1 tk.
5. Patarei, 1 tk.

Video esitlus


 

Kirjeldus Keel Ver. Link
Saatjat torude jaoks tehniline kirjeldus Inglise keel 1805 Duct sondes, EN

Samas kategoorias on veel 11 toodet :