Clamp-on transformer PM80 Vaata suuremalt

Clamp-on transformer PM80

PM80

Uus toode

Clamp-on transformers are special accessories for cable tracers and they are intended to be used when direct galvanic connection to cable is not possible. Such targets are e.g. mains cables or cables whose terminals are not available. Also telecom cables, which can´t be connected to without interference, can often be traced with Clamp-on transformers. The PM80 fits around a cable with 80mm maximum diameter.

When operating with mains cables always remember that clamp-on transformers should never be connected to single mains (phase) wires carrying more than 30A current.

Compatible devices: CTT45, TMT30

Rohkem infot

 

0.87 kg
)

Lisa soovinimekirja

Examples of use PM80

Connecting around the shielding of a cable
Tracing signal is good if one of the wires of the cable (or the shielding) is earthed at both ends. If there are branch-offs or intermediate earthings, signal gets weaker behind them.

Feeding around a wire which is grounded at both ends
This method gives also a good signal. One should however note that when operating with mains cables that clamp-on transformers should never be connected to single mains (phase) wire carrying more than 30A current.

Feeding around wires that are grounded at the far end
This is also a good way of using clamp-on, as long as here is not too high current on a single wire.

Ühendused 2.5m silicone cord with 4mm banana plugs
Mõõdud 240 x 124mm, diameter 80 mm
Kaal Approx. 650g

Hetkel pole ühtegi ülevaadet

Kirjutage oma ülevaade

Clamp-on transformer PM80

Clamp-on transformer PM80

Clamp-on transformers are special accessories for cable tracers and they are intended to be used when direct galvanic connection to cable is not possible. Such targets are e.g. mains cables or cables whose terminals are not available. Also telecom cables, which can´t be connected to without interference, can often be traced with Clamp-on transformers. The PM80 fits around a cable with 80mm maximum diameter.

When operating with mains cables always remember that clamp-on transformers should never be connected to single mains (phase) wires carrying more than 30A current.

Compatible devices: CTT45, TMT30

Kirjeldus Keel Ver. Link
PM34/PM80 Tehniline kirjeldus Inglise keel 1118 PM34/80 Datasheet, EN

Oluline tarneinfo

See seade on võimalik osta Eestis.

Seoses edasimüüja piirangutega, võime tarnida seda seadet ainult järgmistes riikides:

  • Eesti;
  • Läti;
  • Leedu;
  • Vene Föderatsioon;
  • Valgevene;
  • Kazahstan;
  • Ukraaina;
  • Moldova;
  • Gruusia;
  • Armenia;
  • Azerbaidzhan;
  • Tajikistan;
  • Kyrgyzstan;
  • Uzbekistan;
  • Turkmenistan.

Kuisoovite osta see seade teises riigis, mis ei ole loetletud eespool, siis palun andke meile teada ning meie informeerime Teid ostuvõimaluste kohta.

Täname teid mõistva suhtumise eest.

Lugupidamisega,
LSTE Meeskond

Samas kategoorias on veel 2 toodet :