Cable Tracer CT33 is a set containing both Compact Transmitter CTT33 and Compact Locator CL43.
Hoiatus: Viimane toode laos
CTT33 is Vesala’s new general purpose cable tracer transmitter. It is at its best when used with the Vesala CL43 compact locator but it can be used with other brand 33kHz locators as well. CTT33 is small in size so it will fit in places where other bigger transmitters would be to too clumsy, such as small cabinets, and during indoor use. CTT33 is powerful: In Boost mode its output power corresponds to many big outdoor use focused transmitters.
CTT33 can be connected to telecom cables and even directly to 230V live mains wires. With clamp-on transformer e.g. underground cables are equally reachable. Unlike most 33kHz transmitters, CTT33’s output signal can be switched to 4Hz or 8Hz pulsed mode. Pulsed signal is often easier to distinguish from noise. Furthermore pulsed modes enable using the two transmitter method to pinpoint wire cuts in cables.
CT33 can be used for example to:
There are several accessories available for CTT33 and CL43 to make the setup a full featured cable tracing equipment: For CTT33 there is a selection of feeding cords and clamp-on transformers and for CL43 several probes are available. As CL43 is compatible with all Vesala’s duct sondes it is also an excellent starting point to duct tracing.
Logi sisse või registreeru hinna nägemiseks193,00 € Tellimisel Maksudeta
Receiver probe LA43 (Inductive) for use with Compact locator CL43 by Vesala. Frequency: 10kHz and 33kHz (32.768kHz)
Logi sisse või registreeru hinna nägemiseks193,00 € Maksudeta
Logi sisse või registreeru hinna nägemiseks450,00 € Laos Maksudeta
MPL6 is micro-sized transmitter sonde for tracing microduct and other tube blockages. It has only 6.4mm diameter so it fit into ducts having inner diameter of 8mm or more.
Logi sisse või registreeru hinna nägemiseks450,00 € Maksudeta
Palun küsige hinda480,00 € Tellimisel Maksudeta
MPL7 is flexible and only 7mm diameter transmitter sonde for tracing microduct and other tube blockages. It is very useful when new cables are to be pushed into old ducts, which already have installed cables or other obstacles.
Palun küsige hinda480,00 € Maksudeta
MPL9 is flexible and only 9mm diameter transmitter sonde for tracing microduct and other tube blockages. It is very useful when new cables are to be pushed into old ducts, which already have installed cables or other obstacles.
Palun küsige hinda500,00 € Tellimisel Maksudeta
PL18-05 is a low frequency (512Hz) pipe transmitter sonde, which enables tracing of underground cast iron ducts and their blockages. Also stainless steel ducts commonly used in industry can be followed and checked with PL18-05.
Palun küsige hinda500,00 € Maksudeta
Hetkel pole ühtegi ülevaadet
|CTT33 Technical description||English||1704||CTT33 Datasheet, EN|
|CL43 Technical description||English||1637||CL43 Datasheet, EN|